Model 7310 Power Pinner CD Hand Welder
9
READY FOR WELDING
When you have completed all of the previous steps to prepare for welding, attach the ground
cable to the work area, you can now power on the welder.
VOLTAGE SELECTION
-Be sure the Weld unit in in the “VOLTAGE MODE”
-Selecting the required weld voltage is achieved by pressing the “-” or “+” on the Front
Panel Touch Screen. The voltage range is from 35VDC to 100VDC.
-The voltage is determined by the diameter of the stud and the base material. A starting
point for the voltage setting is: .080 dia nail (14 Ga)-75; .106 dia nail (12 Ga)-85; .133
dia (10 Ga)-90.
-Fine tuning the voltage to meet your requirement for the specific application is recom-
mended.
WELDING
With the Ground Clamp in place, place a Weld Pin on the Guns Weld Tip. The magnetic tip
will hold the Weld Pin to the Weld Tip. Push the Weld Pin thru the insulation so the Nail tip
comes in contact with the sheet metal. The Weld Gun is equipped with a spring feature to apply
the correct amount of force to apply the Weld Pin. Push down on the Gun, making sure the
Weld Pin is perpendicular to the sheet metal, to compress the spring approximately 75% of the
spring travel. The “CONTACT” indicator will illuminate when the nail in ready to be welded.
Squeeze the Trigger to start the weld process. The “TRIGGER” indicator will illuminate when
the Trigger is depressed.
Mode Selector
Decrease Voltage Selector
Increase Voltage Selector
Voltage Readout
CONTACT Indicator
TRIGGER Indicator
Status Indicator
