Gripe Lite GRTFR83, Operator'S Manual

Page: 13 / 66

13
MAINTENANCE
MAINTENANCE
Your tool will last longer and perform better if periodic maintenance is
performed. Please use the information below to keep your tool operating
in top condition.
Lubrication
Disconnect tool from the air supply and remove
all fasteners. Apply 2-3 drops of air tool oil
(provided) in the air inlet two - three times a day.
If the tool will be used outside in the winter, use
a winter grade air tool oil to help keep frost from
forming inside the tool. Do not use other types
of lubricants on this tool, as other lubricants may
contain chemicals harmful to o-rings and other
tool components. Drain compressor tanks and
hoses daily.
Cleaning
Disconnect tool from the air supply and remove all fasteners. Brush tool
off using a parts cleaning brush or clean rag. Check area around trigger
and workpiece contact, and clean as necessary.
Trigger Check
Check trigger operation daily to confirm proper sequential operation:
1. Move the selector button on the trigger to the forward position.
2. Press the workpiece contact against a safe work surface without
depressing the trigger. THE TOOL MUST NOT CYCLE.
3. Hold the tool above a safe work surface and pull the trigger with-
out depressing the workpiece contact. THE TOOL MUST NOT
CYCLE.
4. Pull and hold the trigger, and then press the workpiece contact
against a safe work surface. THE TOOL MUST NOT CYCLE.
5. With finger off trigger, press the workpiece contact against a safe
work surface. Keep tool pressed against work surface, and pull
trigger. THE TOOL MUST CYCLE ONCE .
6. The trigger must return to the normal position each time finger
pressure is released.