G-SWS
Assembly and Operating Manual
Centering disc
7 Maintenance and care
7.1 Disassembly of the SWS
(Behold Image 5)
1.
Disassemble the SWS.
2.
Loosen the Setscrew (Pos. 3).
3.
4.
Clean all parts thoroughly. Inspect for wear and defects.
5.
Lubricate all mating surfaces.
For assembly, reverse the order.
7.2 Torque specifications
M6 – 8,5 Nm; M8 – 20,6 Nm; M10 – 41 Nm; M12 – 71 Nm
5
In order to archieve a precise fit, centering discs in every size are offered (as shown in image 3).
The use of a centering disc ensures that the upper assembly and/or lower assembly of the
Connector are properly centered. Installation on both the upper assembly and lower assembly is
possible (as shown in image 4).
Image 3
Image 4
The SWS is virtually maintenance-free. Check the semi-cylindrical bolt in regular intervals for
correct function. Keep the mating surface and the moving parts clean and lubricate them slightly.
Spare parts and component parts of the SWS can be found on our homepage:
www.grip-gmbh.com
To disassemble the semi-cylindrical bolt (Pos. 2) from the other component parts (Pos. 5,
6, 7 and 8), remove the cylinder bolt (Pos. 8).
