Grip Rite GR254CTS, Operating Manual And Parts List

Page: 9 / 40

8
SET UP
Before being used for the first time, your new compressor requires a simple set-up procedure
that will help your unit deliver years of trouble-free service.
WARNING: Failure to follow all initial set-up instructions may result in serious damage
to your compressor, property damage, or serious injury to operator and bystanders. Do not
start compressor until all set-up steps have been performed.
1. Remove dipstick and add lubricant to compressor crankcase. Oil level must be
between “Low” and “High” marks on dipstick. Crankcase capacity is ll.8 oz. (350 ml).
Use chart below for correct viscosity:
Air Temperature Viscosity
14 – 80 F SAE 20 (ISO 68)
40 – 80 F SAE 30 (ISO 100)
2. Install air filter in compressor head, and tighten securely.
3. Check power outlet circuit for correct capacity. Compressor requires 120V, Single
Phase, 14 Amps, 60 Hz. Fuses or circuit breakers must be rated accordingly.
4. Use an extension cord with 3-prong grounding plug sized to prevent power loss and
overheating of the motor:
Cord Length Wire Gauge Size
up to 25 ft. 12 ga.
Up to 100 ft. 10 ga.
Up to 150 ft. 8 ga.
Up to 250 ft. 6 ga.
5. Position compressor on a secure, stable surface, no more than 10 degrees off level.
6. Open one tank drain cock, and start compressor by pulling On/Off button out to the “ON”
position. Allow compressor to run for 10 minutes, then close drain cock.
7. Allow compressor to pressurize tanks. Watch for excessive vibration or unusual noise
while compressor motor is running. If unit vibrates excessively or makes unusual noise,
shut compressor off by pressing On/Off button to “OFF” position. Refer to trouble-
shooting chart for corrective action.
8. Check operation of Pressure Relief Valve by pulling release ring out to exhaust air
pressure from tank. Release ring and allow pressure relief valve to reseat. Contact
your dealer if Pressure Relief Valve does not operate properly.
9. Compressor is now ready for regular operation.