Grindmaster 1WD25-4, Service Manual

Page: 3 / 28

Figure B
UNPACKING
Your dispenser is packed in 2 cartons: base pack and bowl pack.
Unpack base by opening bottom flaps. See Figure A.
IMPORTANT NOTES:
1. Do not leave base upside down as this can damage
refrigeration system.
2. Check that all 4 rubber feet are attached to legs after removing
from base pad. Check base pad or carton for missing feet and
replace on legs.
3. Never lift from louvres/ventilation slots. Instead, place fingers
under base plate.
INSTALLATION
1. Place base on counter.
2. For heated units (HD15/WHD15) units only:
Install Safety Arms
Tools required: Phillips Head Screwdriver
a) Place unit on its side so you have access to the bottom of the unit.
b) Line up arm holes so they line up to the holes on the bottom of the unit; arms
will extend forward as shown in illustration. See Figure B.
c) Attach arms with screws provided.
3. Leave sufficient air space (6”(15cm)) on sides (also rear of D35 triple) for proper
airflow and efficient operation. See Figure C.
IMPORTANT: Failure to provide required airspace can damage unit.
4. Plug into properly grounded, 3 prong outlet.
5. Assemble bowl parts and drain trays. See Assembly instructions that follow.
See Figure D.
NOTE: See pages 8 - 9 for Installing Security Kit Instructions.
1. Roll chassis
up-side down
2. Open bottom flaps.
Fold back.
3. Hold flaps out of way.
Roll the carton over.
4. Lift off carton.
Remove bottom pad.
BOTTOM PAD
CHASSIS
Figure A
Figure D
SPRAY TUBE
3/8” TAB
BOWL
GUIDE PIN
CHASSIS
FRONT
COOLING
PLATE
BEARING SLEEVE
IMPELLER
BOWL
GASKET
PUMP
COVER
LOCKDOWN
WASHER
SET-UP
Crathco® Beverage Dispensers Page 2
6” (15 cm)
(all units)
6” (15 cm)
(D35 only)
Figure C