12
11
PROGRAMMING THE QUANTITY
OF BEVERAGE IN A CUP
Note:
The quantity of coffee dispensed may be programmed,
from a minimum of 30mL
to a maximum of 250mL
.
Note:
Recommended Programming/Factory Programming:
- 30mL: Single Espresso Shot
- 60mL: Double Espresso Shot
- 120mL: Hot Water Button
Note:
Quantities are approximate and may vary slightly between capsules.
Switch the
machine
ON
using
the
On/Off Switch
.
Wait for your
machine to warm
up.
Close the
Lever
fully.
Place a cup or
mug under the
Dispensing Spout
.
Insert the capsule,
pressing it gently
into place.
Press and hold the
desired beverage
button.
On reaching the
desired amount
of beverage,
release the button.
Now the button
is programmed
to your desired
amount.
Raise the
Lever
to
open the
Capsule
Compartment
to eject the used
capsule and lower
the
Lever
.
Raise the
Lever
to
open the
Capsule
Compartment
.
1.
5.
2.
6.
3.
7.
4.
8.
ON
WATER
When the
Indicator
Light
blinks
ORANGE
and the machine
emits 3 beeps it’s
advisable to perform
the
Descaling Cycle
.
Refer to
Page 15
for
Descaling Instructions
.
The
Water Tank
is
empty when the
Indicator Light
blinks
RED
and the machine
emits 3 beeps,
followed by a single
intermittent beep.
When all the
button lights are
lit steadily, your
machine is ready
to use.
Press any one of
the buttons. Wait
for the machine
to complete the
Priming Cycle
as it
fills up with water.
When all the
button lights blink
continuously, the
machine is warming
up.
GENERAL OPERATING INDICATIONS
DESCALING SIGNAL:
HEATING:
WHEN THE WATER RUNS OUT DURING OPERATION:
1.
4.
3.
Fill the
Water
Tank
with fresh
water.
2.
