3) Motor Signal Pass-Thru:
On the L10 model, motor
temperature and speed signals travel through the L1019
motor cable directly to the WP8 plug for the Cycle Analyst.
On the Phaserunner_MT model, there is an extra 2 pin JST
connector available to pass these additional signals to the
Cycle Analyst Plug if desired.
The Phaserunner parameter
Features2[01] “HDQ Replicating
HALL”
can be used to duplicate the motor hall signal on the
CA3's speed line to avoid the need of an external sensor with
direct drive motors.
With geared and mid-drive motors that freewheel, this setting
must be disabled and the
wheel speed sensor
attached to pin 1 of the
JST plug.
4) TRRS vs TRS Jack:
The programming jack appears
identical to prior versions and is compatible with all the USB-
>TTL programming cables offered by Grin. However it now
also contains 5V power on the extra ring contact which will
allow for future addition of a bluetooth wireless dongle.
Because of this extra 5V power, it is important to keep water
out of this programming jack as it would quickly corrode the
positive contacts. A rubber 3.5mm TRS plug is included with
the Phaserunner and this should be re-inserted after using
the programming port.
Pin 1 = Thermistor Pass-Thru
Pin 2 = Speed Signal Pass-Thru
Pin 2 = Yellow Hall
Pin 3 = Green Hall
Pin 5 = Hall 5V
Pin 4 = Blue Hall
Pin 1 = Hall Gnd
