GSS66SS
Page 6
GRILLSTREAM HYBRID SYSTEM
This Grillstream Barbecue comes equipped with the revolutionary
Grillstream Hybrid System enabling you to cook with gas, charcoal
or both!
DIRECTIONS FOR USE - CHARCOAL:
For best results use
Charcoal Briquettes
. While the Grillstream
Hybrid System is suitable to use with Lumpwood Charcoal we would
always recommend using Charcoal Briquettes for a longer, more even
heat output.
STEP 1:
Remove your Grillstream Grills and load the Grillstream Hybrid System
Charcoal Trays with charcoal. If using Charcoal Briquettes load a
single layer, stood up on end (as illustrated) to allow optimal loading.
Place your Grillstream Grills back into position. It is important that
the Charcoal Trays are not overloaded with charcoal – if charcoal is in
contact with the Grillstream Grills please remove some until there is
approximately a 1cm gap between charcoal and grill. Failure to do this
could lead to excessive heat and a sub-optimal cooking experience or
even damage to your barbecue.
STEP 2:
With the Barbecue Hood open, light the burners located below the
Charcoal Trays and leave on maximum for 10 minutes. Leave your
Barbecue Hood open to aid oxygen flow and accelerate the lighting
process. Please note: DO NOT use Lighter Fluid, Lighter Gel, Paraffin
Cubes or any other type of lighting aid.
STEP 3:
Your charcoal should now be lit and making the tell-tale popping and
cracking sounds that indicate this. You should now turn off the burners
completely and close your Barbecue Hood.
STEP 4:
To avoid burning your food it is always recommended that you wait
for the charcoal to become coated by a layer of white ash before
commencing cooking. This is usually around 20-30 minutes after
first lighting the charcoal but this can vary depending on weather
conditions and placement of the Barbecue.
If you have followed the above instructions you will now have at
least 1 hour of cooking time before needing to top-up the charcoal
or relighting the burners and using the Barbecue as a standard gas
model. When adding additional charcoal please be aware the grills will
be very hot and require careful removal using the Grill Lifters supplied
with this BBQ. We would also recommend using heat-resistant BBQ
Gloves (sold separately) when removing the hot grills.
Once you have finished cooking and have allowed adequate time for
the Barbecue to completely cool down, you should carefully dispose of
the Ash that will have collected in the Charcoal Trays and the Grease
Tray. This ash should be emptied after every use.
DIRECTIONS FOR USE - GAS:
The beauty of the Grillstream Hybrid System is that there is no
additional assembly or conversion process required, whether you want
to use it as a Charcoal Barbecue or Gas Barbecue. If you have set the
Barbecue up, as per the Assembly Instructions, you are ready to cook
with Gas.
YOU SHOULD NOT
remove the Grillstream Hybrid System
Charcoal Trays as these function as heat diffusers when using Gas,
ensuring even heat distribution.
- Hook Grill Lifters at opposite
corners of the grill.
- Hook Grill Lifters beneath cross bar
section of both grills.
