20
GRILLCHEF
Fitting the hose connection
(if exchanging)
Release the old connection hose using two flat spanners (14 and 17 mm). Secure the new hose connection to the connection
hose on the appliance as follows:
1. Dismantle the cutting ring connection into the following parts:
– Coupling nut
– Cutting ring
– Gas hose (G7) with locking thread (G8)
2. Push the coupling nut approx. 20 – 30 mm back onto the connection hose for the cooker.
3. Guide the cutting ring, advancing with the greater end, onto the connection hose of the gas cooker, so that the distance
between the end of the hose and the cutting ring is greater than 2 mm.
4. Guide the gas hose (G7) with the locking thread (G8) over the end of the connection hose. Screw the coupling nut and
the locking thread (G8) very tightly together using two fork keys (14 & 17 mm). The cutting ring cuts onto the connec-
tion hose of the burner so tightly that it cannot be manually removed.
connection hose of the burner
coupling nut
cutting ring
G7
G8
Operation
Starting up the burner
Before using, wash the roasting tray (2) thoroughly with warm soapy water and allow both to dry well. Then apply
cooking oil to the top side of both parts. This will prevent the cooked food from sticking to the roasting tray.
1. Check to ensure that ....
– no flammable materials or substances are in close proximity to the cooker. Minimum distance to flammable mate-
rials or substances: 2m above and 1m to the side; distance to flame resistant materials or substances - min 0.25 m.
– the cooker is positioned firmly on a flat, sufficiently large surface area. It must not be moved during operation.
2. Check to ensure that ....
– the burner is fully assembled and has no obvious defects.
– the roasting tray (2) is inserted.
