22
25.3.
MAIN PANEL ILLUMINATION
+ -
CLR
SET
I NCH
MM
RUN
TC- 501B
TC- 501B
TC- 501B
TC- 501B
TC- 501B
TC- 501B
TC- 501B
TC- 501B
I NCH
MM
RUN
Illumination:
1.
Normal situation:
•
Press “CLR” key: Clear current coordinate values.
•
Press “
+
” key: Add 0.01 on current coordinate values.
•
Press “
-
” key: Reduce 0.01 on current coordinate values.
2.
Press “CLR” key to boot-strap and enter the state for parameters setting.
•
Press “CLR” key: Save parameters.
•
Press “
+
” key: Add 0.01 on current digit and cycled among 0-9.
•
Press “
-
” key: Finish current digit setting and enter to next digit.
3.
Press “
+
” and “
-
” keys to boot-strap and ready for switching between mm and inch. (Don’t forget to modify
corresponding parameters)
4.
Indicator lights:
•
Run: Motor running.
•
Mm: Measurement.
•
Inch: Measurement.
5.
Display: Display six digits totally.
•
The tiptop digit shows sign (It shows nothing when the value is positive number and show “
-
“ when it
is negative value).
•
The rest digits show number values. Three digits before radix point and two digits after radix point.
Scale: -999.99mm – 999.99mm (or -999.99inch – 999.99inch).
25.4.
MANIPULATION PROCEDURE
25.4.1.
PARAMETERS SETUP
When first started up, the machine directly enters the state of parameter setup. (See sketch map b below).
When machine is first installed or reinstalled to another lathe, parameters should be setup depended on current
circs according to the following steps:
a.
Press “CLR/SET” key to turn on TC-501B.
+ -
CLR
SET
I NCH
MM
RUN
TC- 501A
TC- 501A
TC- 501A
TC- 501A
TC- 501B
TC- 501B
TC- 501B
TC- 501B
I NCH
MM
RUN
+ -
CLR
SET
I NCH
MM
RUN
TC- 501A
TC- 501A
TC- 501A
TC- 501A
TC- 501B
TC- 501B
TC- 501B
TC- 501B
I NCH
MM
RUN
(
a
)
(
b
)
b.
Keep on press “CLR/SET” key until the tiptop digit number begins to blink.
c.
Press “
+
” key to set current digit. Add 1 on current digit once press the key. The number cycles among 0-9.
+ -
CLR
SET
I NCH
MM
RUN
TC- 501A
TC- 501A
TC- 501A
TC- 501A
TC- 501B
TC- 501B
TC- 501B
TC- 501B
I NCH
MM
RUN
+ -
CLR
SET
I NCH
MM
RUN
TC- 501A
TC- 501A
TC- 501A
TC- 501A
TC- 501B
TC- 501B
TC- 501B
TC- 501B
I NCH
MM
RUN
(
c
)
(
c
)
d.
Press “
-
” key to save current digit setting and enter next digit. Current digit stops blink and next one begins
to blink.
