grifco.com.au
grifco.co.nz
WIRELESS WALL CONTROL – MODEL E138G
WARNING
For use with
eDrive
2.0 with radio-on-board.
To prevent possible SERIOUS INJURY or DEATH from a moving door:
•
Use Wireless Entry Device within sight of the door and out of reach of children
•
ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote
controls.
•
Ac
�
vate door ONLY when it can be seen clearly, is properly installed, and there are no obstruc
�o
ns to the door travel.
•
ALWAYS keep the door in sight un
�l
completely closed. NEVER permit anyone to cross the path of a moving door
•
NEVER allow small children near ba
�
eries. If ba
�
ery is swallowed, immediately no
�
fy your doctor.
GRIFCO FRONT PANEL
PROGRAMMING
1.
UP
- Moves the door upwards
2.
DOWN
- Moves the door downwards
3.
STOP
- Stops the door
4.
SET
-
SET bu�on
5.
POWER ON
- Shows when the unit is
mains powered
6.
STATUS
- Shows the status of the unit
7.
LIMIT ERROR
– When lit indicates
limits are not set
TOP
Bu
�
on
LOWER
Bu
�
on
To program the
E138G
Wireless Entry Device ensure the radio lock
is removed then perform the following steps:
1. Press and hold the
SET
bu
�
on on the GRIFCO front panel,
then
2. While holding the
SET
bu
�
on, press the
STOP
bu
�
on 5
�
mes
(the
green
status light will light then con
�
nue
fl
ashing,
indica
�
ng learn mode)
3. Let go of the
SET
bu
�
on
4. Press the
E138G TOP
bu
�
on
5. Then press the
E138G LOWER
bu�on
6. The orange
LIMIT ERROR
light will
fl
ash each
�
me to
acknowledge the bu
�
on has been pressed.
7. Press
STOP
bu
�
on on the GRIFCO front panel (the green light
will con
�
nue to
fl
ash).
8. Press the
E138G LOWER
bu
�
on again
9. The green light will go out indica
�
ng exit learn mode.
10. Install the RADIO LOCK key on the eDrive2 board to prevent
any further wireless entry devices being learned.
E138G
Wireless Wall
Control
OPERATION
The E138G TOP bu
�o
n can be used to TOGGLE the ac
�
on of the door between
close
/
stop
/
open
if an obstruc
�
on detec
�
on device is installed,
or
stop
/
open
only if no obstruc
�
on detec
�
on device is installed.
The E138G LOWER bu
�o
n can be used to CLOSE the door. If no obstruc
�
on detec
�
on device is installed, the LOWER key must remain pressed to complete the door close sequence.
+
