GRIDIRON Multi-Purpose Portable Table
Instruction Manual
5
Important Instructions
1�
Follow safety instructions before transporting the table to another location� It is
important to remove all cutting material before transport to avoid injury� Always
drain the water tank before transporting or otherwise handling the table�
2�
Before transporting the table, you can remove the water tank, grid, plasma power
supply/welder shelf and, if necessary, also the CNC unit with rail�
Safety Information
Servicing and maintenance of the installed device must only be performed by trained personnel�
Once the table is installed, you must check the proper functioning of its safety features� Make sure
that all persons working with the table are duly instructed and follow approved procedures and
specifications�
Read the following instructions carefully before using the table:
•
Always keep the instruction manual on hand�
•
Perform regular maintenance to ensure the table is fully functional�
•
Ensure the water in the tank is changed regularly and dispose of contaminated water in
accordance with valid legislation on handling hazardous waste�
•
Once the table is placed where you intend to use it, always secure it against movement using
the brakes on the casters�
Maintenance Instructions
Relocating the Table
Before relocating the table to the chosen spot, drain the water from the tank using the drain valve�
More details below� Extend the arm of the CNC unit so that the torch is as far from the CNC unit as
possible� Disconnect the plasma power supply from power and remove it from the shelf� Remove
the cut material from the grid�
Then release the caster brakes and move the table to the chosen spot�
Be mindful of personal safety during transport: secure the water tank, grid and shelf from sliding/
falling out�
