Page 2
pushbutton to select the switching point (e.g. 5.05 m/s = NC) of the relay. The chosen value (m/s) is shown
on the display. Remove and store the jumper after the configuration is complete.
To configure the hysteresis (display required) install a jumper to pins labeled hyst. as shown in Figure 7.
Press down on the pushbutton to select the hysteresis of the relay switching point. The chosen value (m/s)
is shown on the display. Remove and store the jumper after the configuration is complete. The hysteresis
maximum setting is based on the range selected.
NOTE: The configuration jumpers must be removed and stored for proper operation.
Figure 4
Figure 5
Figure 6
Figure 7
NC
COM
NO
Tout
Vout
24 V
GND
Tout
Vout
24 V
GND
Analog Input 1
Analog Input 2
Power Supply
Common
Controller
NC
COM
NO
Jumper Placement
Jumper (J1): Installed
Jumper (J2): Not installed
Range 2 (0-2 m/s)
Range 10 (0-10 m/s)
Range 20 (0-20 m/s)
Jumper (J1): Not installed
Jumper (J2): Installed
Jumper (J1): Installed
Jumper (J2): Installed
J1
J2
J1
J2
J1
J2
No jumper
Circuit open
Jumper installed
Circuit closed
Jumper stored
Temperature output (Tout): T = voltage (V)
Velocity output (Vout): V = voltage (V)
Temperature output (Tout): T = current (mA)
Velocity output (Vout): V = current (mA)
Temperature output (Tout): T = voltage (V)
Velocity output (Vout): V = current (mA)
Temperature output (Tout): T = current (mA)
Velocity output (Vout): V = voltage (V)
V mA
V mA
V mA
V mA
NC
COM
NO
Tout
Vout
24 V
GND
Push button
T
V
J1
J2
sw. p.
hyst
V mA
IN-GE-AVDTXXX-01 03/20
Copyright © Greystone Energy Systems, Inc. All Rights Reserved Phone: +1 506 853 3057 Web: www.greystoneenergy.com
