Greyp G 6.1, User Manual

Page: 20 / 60

BATTERY AND CHARGER
18
WARNING! Failure to follow the instructions in this section may result in damage to electrical
components on your vehicle and will void your warranty, but, most importantly, may result in
serious personal injury or death. If your battery or charger exhibits any signs of damage, do
not use it and immediately bring it to your authorized Greyp Bikes retailer for inspection.
WARNING! It is important that you follow the instructions on the label of the battery charger
The battery can be charged whether installed in the vehicle or not. Refer to the appropriate
instructions regarding removing and installing the battery. Only charge the battery at an am
-
bient temperature between 10°C and 30°C (50°F and 86°F). If the outside temperatures are
too hot or too cold, charge the battery inside. For safety reasons, if the battery is too hot or
too cold, it will not charge.
Charging process
Plug the charger plug into appropriate AC outlet (depending on the charger) using the appro -
priate for the country’s standards.
(QQE input voltage: AC, 50-60 Hz, 90-264 V – FAST CHARGER ON REQUEST)
Uncover the charging socket on the bike, then connect the charger to the charging socket on the
bike. It is possible to charge the battery when removed from the bike. In that case, plug the charger
into the battery socket.
During the charging process, the diode on the charger will glow red. When the battery is fully
charged, the diode on the charger will turn green. When monitoring the charging process,
please check the LED light on the charger.
When charging is complete, disconnect the charging plug from the battery socket. Unplug the
charger from the wall socket.
on bike
on battery
Charging sockets