SKU 66663
For technical questions, please call 1-800-444-3353.
Page 11
Figure 4
Vertical Position
Place
Log
Here
Base
In FIGURE 1, the Rail Assembly (2) is
2.
shown in Horizontal mode for opera-
tion and travel. In FIGURE 4 the unit
is shown in the vertical position. To
change positions, remove the Hair
Pin Clip (29) and the Push Pin (26). A
close-up of this Push Pin is shown in
FIGURE 3. Tilt the unit to the vertical
position as shown in FIGURE 4, and
replace both the Push Pin and the
Hair Pin Clip into the vertical position
hole (See FIGURE 1). Reverse the
process to return to the horizontal
position.
Start and operate the engine accord-
3.
ing to the provided engine manual.
The maximum length of each log can
4.
not exceed 25 inches or a diameter of
8 inches.
Place the log on the Rail Assembly
5.
(2) near the Base as shown in FIG-
URES 1 and 4. Make sure the wedge
on the Slide Assembly (3) is facing
the log. (See FIGURE 1).
Grip the Directional Valve (58) and
6.
move it into the lower position to split
the log.
To back the wedge off the log, move
7.
the Directional Valve away from the
log just split.
Once the log is split, remove the piec-
8.
es. Continue, as explained above,
until all logs are split.
To prevent accidents, turn off the
9.
engine and disconnect its spark plug
wire after use. Wait for the engine to
cool, clean external parts with clean
cloth, then store the equipment out
of children’s reach according to the
Storage instructions in this manual.
