REMOTE CONTROL
33
USER MANUAL
SBUS/PPM
SETTINGS
RECEIVER CONNECTION
SBUS/PPM port is located on the Hyper Quick Release and the gimbal controller.
PPM port is located in the Roll housing.
The receiver must be connected to correct wires order. The SBUS/
PPM port has 5V output to power the receiver, please do not use
external power supply to power the receiver at the same time. Doing
so may damage the electronic inside the gimbal.
WARNING
There are 6 channels to assign
: MODE, TILT, ROLL, PAN, TILT SPEED, PAN SPEED
.
Assign MODE channel first then follow the order above because MODE channel
is used to change operating modes of the gimbal and should be assigned to a
3-position switch as follows:
Switch at high position
: FOLLOW MODE , MOTORS ON
Switch at middle position
: LOCK MODE , MOTORS ON
Switch at low position
: MOTORS OFF
