REMOTE CONTROL
CHANNEL SETTINGS
There are 6 channels to assign : MODE, TILT, ROLL, PAN, TILT SPEED, PAN SPEED.
TILT and PAN channel should be in speed mode and ROLL channel in angle mode.
TILT SPEED or PAN SPEED could be assigned to the same channel and should be assigned to throttle stick,dial, or other non-centering control on the
transmitter.
Below is an example of channel assignment to the Futaba T8FG.
Assign MODE channel first then follow the order above because MODE
channel is used to change operating modes of the gimbal and should be
assigned with a 3 position switch as follows:
Switch at position 1: FOLLOW MODE , MOTORS ON
Switch at position 2: LOCK MODE , MOTORS ON
Switch at position 3: MOTORS OFF
SBUS/PPM SETTINGS
Pos 01
Pos 02
Pos 03
MODE channel
CHANNEL
CONTROL
NOTE
MODE
5
SC
3 positions switch
TILT
2
J2
Speed mode
ROLL
4
T4
Angle mode
PAN
1
J1
Speed mode
TILT SPEED
3
J3
PAN SPEED
6
RD
25
Summary of Contents for H3
Page 1: ...GREMSY H3 USER MANUAL Ver 1 6 ...
Page 35: ...gremsy com ...