T20.0.4X.6C-03
Operating Manual GTMU - MP
page 3 of 6
_____________________________________________________
_____________________________________________________________________________
5 Assignment of elbow-type plug (depending on type)
4-20mA (2-wire connection)
voltage (3-wire connection)
voltage (4-wire connection)
1
= supply vUv
1
=
1 =
2
= GND / signal
3
= supply vUv
2 = signal -
(4)
= supply voltage -Uv
3
= supply vUv
signal -
(4)
= supply voltage
–Uv
The type “current-” or “voltage output” is set by works and cannot be changed.
6 General installation instructions:
To mount the connection cable (2-, 3-, or 4-wire depending on type of device) the elbow-type plug screw has
to be loosened and the coupling insert has to be removed by means of a screw driver at the position
indicated (arrow).
Pull out connection cable through PG gland and connect to the loose coupling insert as described in the
wiring diagram. Replace loose coupling insert onto the pins at the transducer housing and turn cover cap
with PG gland in the direction desired till it snaps on (4 different starting positions at 90° intervals). Re-tighten
the screw at the angle plug.
7 Design types, dimension
design-type 1 design-type 2 design-type 3
design-type 4
