EN - 26
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Motor buzzes but fails to
run.
Supply voltage below
minimum.
Verify that only the pressure washer is running
on this circuit.
System has residual
pressure.
Turn unit “OFF”, squeeze trigger on spray
wand to release pressure, then turn unit "ON".
Voltage loss due to
extension cord.
Unplug any extension cords attached and plug
the unit directly into the outlet.
Pressure washer not
used for long periods.
Call the Toll-Free Helpline.
Residual friction
among components.
Unit might hum.
Disconnect water supply and power ON for 2
to 3 seconds, repeat couple times or until the
motor starts.
No water.
Water supply is OFF.
Turn ON water supply.
Kink in the garden
hose.
Remove kink in garden hose.
NOTE: AUTO ON/OFF SWITCH: This Pressure washer is equipped with an Auto Start/
Stop feature. To operate: Press power switch On (I). Pump will pressurize and shut
down immediately. Once the trigger of the gun is depressed the unit will turn on. Unit
will shut off and be in standby mode when trigger is released.