19
2. Pull and remove the spool cover (20).
21
20
3. Remove the remaining spool (21).
4. Put the spool in the spool housing.
NOTE
Make sure that you put the cutting line in the slot on
the new spool and extend the line approximately 15
cm before you install the new spool.
5. Put the ends of the cutting lines through the holes.
6. Extend the cutting line to release it from the guide
slot in the spool.
7. Push the tabs and install the spool cover onto the
spool housing.
8. Push the spool cover until it clicks into position.
9.5
REPLACE THE CUTTING LINE
NOTE
Remove the remaining cutting line on the spool.
NOTE
Use only with the nylon cutting line of 0.080" (2.0 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into
the slot in the center rim of the spool. Make sure
that the line snaps into position in the slot.
3. With your finger between the lines, wind the lines
equally and tightly around the spool in the indicated
direction.
4. Put the lines in the guide slots.
5. Do not wind the lines beyond the edge of the spool.
20
21
9.6
REMOVE THE TRIMMER HEAD
1. Put the metal rod (E) in the specified angle
transmission hole (D) to fix the trimmer head.
2. Remove the spool cover and the spool.
21
20
3. Loosen the nut (J) on the trimmer head clockwise
with a wrench.
4. Remove the trimmer head.
9
English
EN