Greenwit MOTORINO XPv, User Manual

Page: 9 / 24

ASSEMBLY INSTRUCTIONS
8
HANDLE BAR
Insert the top part of the handlebar into the handlebar post as shown on the picture. Locate
the attachment bolt with the nut and the spacer. Place the curved side of the spacer over the
hole on the front of the bar, insert the bolt through the spacer and the bar, screw the nut in
behind and tighten it. After attached, the handlebar should look as on the picture below.
Your Motorino will come in one of three different states:
a) 95% assembled - you only need to install the mirrors and the cargo box
b) 90% assembled - you need to install (a) plus front wheel
c) 85% assembled - you need to install (b) plus the handle bar and some plastic elements
All instructions for (a), (b) and (c) are described below with supporting pictures
FRONT WHEEL ASSEMBLY
If the front wheel of your bike is
assembled, proceed to the next
section. Otherwise read below:
Before installing the front wheel
gently take apart disk break pads
using a wide flat screwdriver so the
wheel disk can squeeze between the
pads. Push the black speedometer
cap against the wheel and position
it in the way that the axle bolt can go
through it. Be sure that the two teeth in
the speedometer cog properly mate with the wheel. Firmly tighten the nut at the opposite side.