Example:
For 12” ceiling joist the optimal distance from side to side would be 60” to attach to wood.
For 16” ceiling joist the optimal distance from side to side would be 64” to attach to wood.
3) Installation:
a. Use the template provided to mark holes for drilling or screwing into the ceiling.
Note: the two pulley systems must be in parallel to
each other. For best results a tape measure can be
used.
b. Drill the holes into the ceiling and install one pulley
system and repeat for the other side.
Note: if you do not hit a ceiling joist, use plugs
into the drywall
c. Add the 3 Stainless Steel rods to the unit by placing
the hook through the end of the rods.
d. Add the small white plastic ends to each of the hooks.
e. Option: add one or more easy hang tabs to each of
the rods for hanging hangers.
DO NOT CUT THE NYLON
CORD UNTIL YOU HAVE READ
THIS SECTION!
4) Decide on the length of
nylon cord by ensuring all
bars are level
Note: You may want to leave the cords uncut for a few days until you use the
LaundryLift
®
and determine the length of cord that suits you.
a. Cut the looped cord to your desired length, you now have two equal cords.
5) Attach the child resistant safety clips
a. Place one of the nylon cords into the “A” side of the child resistant clip and tie a knot.
b. Place the other nylon cord into the “B” side of the child resistant clip and tie a knot.
c. Snap the two sides together to make the system complete.
6) Install the nylon cord separator to the wall by finding the wall
stud or using the
plugs and attach using
the screws provided
a. Place the cords into
the cord separator in
order to keep the cords
out of the way when
your Laundry Lift
®
is
not in use.
2
Tools Required:
• Stud Finder
• Pencil
• Screwdriver/drill
• Measuring tape
• Step stool/ladder
Each package should have:
• 3 Stainless Steel Rods
• 2 pulley systems for mounting on the ceiling
• Pre strung nylon card with 6 hooks
• Nylon cord holder
• Hardware
1
