Greentek Alaska Island inox, Manual

Page: 7 / 28

7
EN
Mounting
Very heavy product; hood handling and installation must be carried out
by at least two persons.
Before beginning installation:
▶ Check that the product purchased is of a suitable size for the
chosen installation area.
▶ Remove the charcoal (*) filter/s if supplied (see also relative para-
graph). This/these is/are to be mounted only if you want lo use the
hood in the filtering version.
▶ Check (for transport reasons) that there is no other supplied ma-
terial inside the hood (e.g. packets with screws (*), guarantees (*),
etc.), eventually removing them and keeping them.
▶
If possible, disconnect and move freestanding or slide-in range
from cabinet opening to provide easier access to rear wall/ceil-
ing. Otherwise put a thick, protective covering over countertop,
cooktop or range to protect from damage and debris. Select a flat
surface for assembling the unit. Cover that surface with a protec-
tive covering and place all canopy hood parts and hardware in it.
▶ In addition check whether near the installation area of the hood
(in the area accessible also with the hood mounted) an electric
socket is available and it is possible to connect a fumes discharge
device to the outside (only suction version).
▶
Carry out all the masonry work necessary (e.g. installation of an
electric socket and/or a hole for the passage of the discharge
tube).
Expansion wall plugs are provided to secure the hood to most types
of walls/ceilings. However, a qualified technician must verify suitability
of the materials in accordance with the type of wall/ceiling. The wall/
ceiling must be strong enough to take the weight of the hood. Do not
tile, grout or silicone this appliance to the wall. Surface mounting only.
OPERATION
Use the high suction speed in cases of concentrated kitchen vapours.
It is recommended that the cooker hood suction is switched on for 5
minutes prior to cooking and to leave in operation during cooking and
for another 15 minutes approximately after terminating cooking.
To select the functions of the hood, simply touch the controls.
1. OFF motor
Pressing the button during functioning, the hood turns
OFF.
2. Speed Increase
Pressing the button the hood passes from the OFF
state to speed 1.
Pressing the button (hood in ON state) the motor
speed is increased from speed 1 to intensive.
To each speed corresponds the ignition of the respec-
tive led.
Speed 1: 1
Speed 2: 2
Speed 3: 3
Speed 4: 4 / Intensive mode of work BOOST. Used with
large amount of vapour during cooking. Cooker hood
automatically will switch into third speed, after 5 min.
of work.
3. Function state indicator
4. Speed timing
5. ON/OFF lights
Speed Timing
Timer: to enable programming automatic switch off at any given time
between 10 and 90 minutes, with 10-minute increments.
To enable programming function, turn the engine on using the “+” but-
ton to the level you want, and then press the button to program the
1
2
4
5
3