GreenTec HXF 2800, Handbook

Page: 24 / 27

HXF 2800 / 2802 AHS
24
Oil Supply
•
Daily before starting up check oil level in tank reservoir.
•
It is a good practice to constantly keep an eye on the tank level gauge, (this can be seen from
the tractor seat) as a pipe burst could empty the tank within minutes.
•
A pump or motor starved of oil will be damaged beyond repair.
•
Replace oil if signs of contamination occur (discolouration)
•
Contamination can be reduced by
- Thoroughly cleaning around reservoir cap before removing
- Using a clean container when replenishing the system
- Regularly servicing the filtration system
- Never allowing oil level to fall below the sight gauge
•
Daily inspect all hydraulic connections and fittings to be in good order. Any damage or leaks
must be rectified immediately; this is part of the daily maintenance and is your responsibility, to
maintain a long reliable working life.
•
When tightening fittings always use two spanners when necessary and do not over tighten. If a
fitting leaks it will need to be replaced
Maintenance chart
Service
Hours Service points Grease Drain Control Clean Change
1 – 4 hours Bolts are completely tightened X
Seals at valve block (If leaking, replace
them) X ( X )
Check for leaks from fittings and hoses X
Bolts and bushes greased and tightened X