RT-10 Rope Tester
5
52093863 REV 0
© 2020 Greenlee Tools, Inc.
Operating Instructions
Test rope as close to the time of use as possible. Variations
in humidity over time make it possible for the same rope to
test non-conductive at one time and conductive at another.
Do not touch clamps while unit is ON.
1. Confirm proper operation. Place a section of insulated
wire with stripped ends between the two clamps. With
hands clear, depress the power button to turn the unit
on. Confirm that the LEDs illuminate and the buzzer
sounds. Turn unit OFF. Do not use the unit if it is not
working properly.
2. Open clamps and place rope across clamps.
3. Close clamps over the rope.
4. Turn unit ON. With one hand, grip the tester handle to
keep the tester steady
5. With the other hand, pull the rope through the
clamps. Keep a steady pace. The tester works in both
directions. If rope is conductive the red LEDs will light,
and the buzzer will sound. Pulling the rope too quickly
increases the risk of not detecting conductive sections
of the rope.
6. After testing the rope, reconfirm proper operation of
the rope tester. See step 1. Do not use the rope if the
tester doesn’t pass the test. Change the tester battery
and test rope again. If the unit still does not operate
properly, send unit in for repair. Test the rope again
with a different unit.
7. Turn the tester OFF.
Battery Replacement
When the Power button begins to flash, the batteries are
low, and need to be replaced.
1. Turn off unit and turn over.
2. Loosen the two thumbscrews and remove the battery
door.
3. Install new batteries. Lithium 9V batteries are recom-
mended for best performance. Do not mix old and new
batteries, or batteries of different types. Pay attention
to battery polarity.
4. Replace the battery door and secure with
thumbscrews.
5. Turn tester on. Light should be solid. If light is flash-
ing or tester will not turn on, check battery polarity or
replace batteries again. If tester does not function as
expected, send in for service.
6. Confirm proper operation of the unit using the proce-
dure at the beginning of the operation section.
Cleaning
Turn unit off before cleaning. Clean the unit with a soft
cloth dampened with only water. Dry completely before
use or storage. Do not use harsh chemicals or solvents.
Service
Have your tool serviced by a qualified repair person using
only identical replacement parts. This will ensure that the
safety of the tools is maintained.
Do not modify this tool. Modifying the tool in any manner
may result in personal injury and damage to the tool.
Do not attempt to open the tool. It contains no user-ser-
viceable parts, besides the batteries.
If any damage is found or the unit will not turn on after
replacing the battery, send in for service.
• Check for damage and any other condition
that may affect the tool’s operation.
Do not use
this product if it is damaged or not working as
expected. Remove from service and arrange for
repair or replacement before use. Many accidents
are caused by poorly maintained tools. A dirty or
damaged tester increases the risk of false readings
and increases the risk of electrical shock when
using the rope.
Disposal
Do not dispose of electrical equipment with household
waste! Parts of this tool contain valuable materials and
can be recycled. There are companies that specialize
in recycling that may be found locally. Dispose of the
components and any waste oil in compliance with
all applicable regulations. Contact your local waste
management authority for more information.
For EC Countries:
Do not dispose of electrical equipment
with household waste! According to the European Guideline
2012/19/EU for Waste Electrical and Electronic Equipment
and its implementation into national legislation, electrical
equipment that is no longer usable must be collected
separately and disposed of in an environmentally correct
manner.
B
