6
Features
• Testing for wiring faults of open, shorted, reversed, crossed, and split pairs
• Split pair fault detection at a minimum 0.4 m (16") cable length
• Testing of twisted pair cables to over 200 m (656 ft)
• Tone generator for tracing installed cables and locating faults
• One-person identification of up to four remote terminators
• Verification of shield integrity
• Easy-to-read fault display and high speed testing
• “Debug mode” for detailed fault identification results
• “Auto sleep mode” and power off switch to decrease power consumption
Operation
Testing a Cable
1. Slide the switch to
Cable
.
2. Plug one end of the cable into the RJ45 jack on the main unit and the other end into the
RJ45 jack on any remote terminator.
3. Press the
TEST
button and check the results:
• First, check the five horizontally aligned green LEDs (1-2, 3-6, 4-5, 7-8, and SHIELD):
Solid light:
Good pair
Flashing light:
Faulted pair
No light:
Open pair
• Simultaneously, check the first four vertically aligned LED indicators (SHORT,
REVERSED, MISWIRE, and SPLIT PAIRS) to identify any existing wiring faults.
• For more detailed information about what faults are occurring in which pairs, hold the
TEST
button for 2 seconds to activate “debug mode.” The tester will test each pair one
by one, pausing briefly on each pair, and display the corresponding fault status.
Summary of Contents for PairMapper
Page 8: ...8 Fault Status Shorted Pair 3 6 3 6 Open Pair 1 2 1 2 1 2 1 2 Reversed Pair...
Page 20: ...20 Estado de la falla 3 6 3 6 1 2 1 2 1 2 1 2 Par invertido Par abierto Par cortocircuiteado...
Page 32: ...32 tat du d faut 3 6 3 6 1 2 1 2 1 2 1 2 Paire invers e Paire ouverte Paire court circuit e...
