Greenlee Textron / Subsidiary of Textron Inc.
10
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
EK06AT and EK06ATC
Troubleshooting
Tool is inoperative.
Dirt, contaminants, etc., in ram area
Clean tool.
of tool.
Crimping tool battery contacts damaged.
Reform contacts.
Tool components worn or damaged.
Return tool to an authorized
Greenlee service center.
Ram does not advance com-
Oil level is low.
Check oil level. Refill reservoir.
pletely.
Air in hydraulic system.
Pull trigger and hold retract button
simultaneously. Hold for approximately
10 seconds.
Battery load display flashes
Battery charge low.
Charge or replace battery.
constantly.
Tool loses oil.
Damaged internal seal.
Return tool to an authorized Greenlee
service center.
Oil plug not installed properly.
Refill reservoir and replace plug.
PROBLEM
PROBABLE CAUSE
PROBABLE REMEDY
Before You Begin
1.
Make sure that the battery is charged. Recheck
the battery after several minutes to make sure the
battery is holding its charge.
2.
Use a NONFLAMMABLE contact cleaner or pencil
eraser to clean the electrical contacts on the battery
and crimping tool.
3.
Reinstall battery and check the tool again.
