4
Important Safety Information
(cont.)
Electric shock and fire hazard:
• Do not expose this unit to rain or moisture.
• Do not use the unit if it is wet or damaged.
• Clamp meter, leads or any other clamp accessory, when used to make a
measurement, create a System. The System is rated for CAT IV 600 V
when using the leads or accessories provided with the meter. The System
CAT and voltage rating is limited by the lowest rated component in the
System when using leads or accessories not provided with the meter.
• Inspect the leads or accessory before use. They must be clean and dry, and the
insulation must be in good condition. Do not use the test lead if the contrasting
inner layer of insulation is visible.
• Use this unit for the manufacturer’s intended purpose only, as described in this
manual. Any other use can impair the protection provided by the unit.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
• Do not apply more than the rated voltage between any two input terminals, or
between any input terminal and earth ground.
• Keep hands and fingers below the barriers on the leads and the clamp meter body.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
• Do not operate with the case open.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
• Unless measuring current, shut off and lock out power. Make sure that all capacitors
are discharged. Voltage must not be present.
• Using this unit near equipment that generates electromagnetic interference can
result in unstable or inaccurate readings.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
• Do not attempt to repair this unit. It contains no user-serviceable parts.
• Do not expose the unit to extremes in temperature or high humidity. Refer to
“Specifications.”
Failure to observe these precautions may result in injury and can damage the unit.
www.
.com
1.800.561.8187