09
GREENIS
POWER BLENDER
GREENIS
POWER BLENDER 10
It is essential to tap the SAVE “ ” button to save each step, otherwise it will not be included in
the final program.
A recipe that has been correctly programmed will replace the previous DIY program.
The machine may beep to indicate an error with the programming. In this case, the existing recipe
program will not be replaced.
Recipe programs are limited to 15 minutes of continuous use, to preserve the motor.
If the recipe program exceeds 15 minutes, then the machine beeps twice to indicate an error.
A recipe program is composed of a maximum of 18 steps. The display will show “FULL” to
indicate the full limit for steps.
DIY editing mode will be exited after 3 minutes without any operation and the steps will not be saved.
Under DIY editing mode, removing the jar will turn off the machine without saving the new program.
A valid DIY program will be stored in the memory of the machine, whether the machine is
connected to power or not.
Speed 1-12 should be used for roots and leaves of vegetables, fruits, etc. Use an ingredient to
water ratio of 2:3. Ensure that the volume does not exceed the maximum fill line (2 L) of the jar.
Speed 13-24 should be used for ice cubes (individual ice cube size no larger than 20*20 mm) or
nuts(no more than 250 g). Water should not be added when grinding nuts.
IMPORTANT:
While running the machine either by pressing the PULSE button or rotating the
DIAL, above instructions should also be followed when selecting a proper speed(s) depending
upon the type(s) of ingredients mentioned above in order to preserve blades and motor.
Tips:
DIY programming feature is suitable ONLY for common fruits and vegetables that are not
overly thick. A DIY recipe program is composed of a maximum of 18 steps. DIY Recipe programs
are limited to 15 minutes of continuous use, to preserve the motor.
PRECAUTIONS ON PROGRAMMING
STEPS OF DIY RECIPE:
DIY RECIPE INSTRUCTIONS
Start (tap to run DIY program cycle)
Cancel (exit DIY editing mode)
Rotate to set speed
Press dial to switch
between speed setting
and time setting
Press and hold to enter editing mode
Save entire program
DEFINITIONS OF BUTTONS UNDER
DIY EDITING MODE
HOW TO SELF-PROGRAM A DIY RECIPE:
A recipe program consists of several steps that vary in terms of speed and time.
Hold the DIY button for 3 seconds to enter DIY editing mode (the display will show “DIY”.) To edit
the 1st step, rotate the dial to select desired speed or time, whichever comes first. Press the dial to
switch between speed setting and time setting. Tap “ ” button to save the 1st step. The
display shows “SAVE 01” to indicate success of step 1 being saved. Repeat this process for each
step. Each step must be saved by tapping the “ ” button. The recipe program can be composed
of up to 18 steps.
After all your desired steps are saved, tap “ ” to save the entire program. Then the machine
will stand by with your DIY cycle automatically selected. Tap the power button “ ” to run the
new DIY program. Your very own Smart Blend program has now been saved. As with other smart
programs, tap the DIY icon and then the “ ” icon to start running the saved program.
Save each step
