Figure 5 Fabra hood Form F 471322
Figure 6 Fabra hood Form F 471322
NYLOC NUT
Step 6
Attach the END ANGLE (hand tight) to the ends of the SIDE FILTER CHANNEL ASSEMBLIES and SIDE CHANNELS
using four 5/16 X 1 weldstud fasteners per END ANGLE, see Figure 5. In addition, units with throat widths greater
than 36 inches will require FILTER END CHANNEL ASSEMBLIES, see Figure 5, Detail D. Fasten FILTER END
CHANNEL ASSEMBLY (hand tight) to the END CLOSURE ANGLE and END ANGLE, using two 5/16 X 1 weldstud
fasteners per assembly.
Step 7
Slide FILTERS in from both ends of unit. Tighten all FILTER CHANNEL and END ANGLE fasteners only after
FILTERS are in place.
Step 8
Attach the HOOD RAIL ASSEMBLY to the HOOD SUPPORT ANGLES using 3/8 x 3/4 inch bolt with 3/8 inch
Nyloc nut at each attachment point, see Figure 6.
NOTE: Fasteners should be hand tightened only until step 10.
Figure 5
Figure 6
Fabra Hood • Form F
3
®
