![background image](http://html1.mh-extra.com/html/greencut/src350c/src350c_instruction-manual_2261546060.webp)
60
TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies.
PROBLEM
CAUSE
SOLUTION
The saw blade breaks.
A. Too much tension on the
blade.
A. Reduce blade tension.
The saw blade comes
out of the rollers.
A. The blade and rollers are not
aligned properly.
A. Adjust the alignment of the blade
and roller.
Saw blade wobbles,
can't cut straight.
A. Insufficient blade tension.
B. Set of knife guides too high.
C. Blade guides or backpressure
bearings are not properly
adjusted.
A. Increase blade tension.
B. Make sure the height of the blade
guide is adjusted just above the
height of the workpiece.
C. Adjust knife guides and backpressure
bearings.
Squeaking sound
when the machine is
running or cutting.
A. Insufficient blade tension.
B. Blade guides or backpressure
bearings are not properly
adjusted.
A. Increase blade tension.
B. Adjust knife guides and backpressure
bearings.
The saw blade stops
during use or loosens
after the machine is
turned off.
A. Insufficient blade tension.
A. Increase blade tension.
The engine won't
start.
A. No power supply.
B. Thermal overload
triggered.
C. Electrical or motor failure.
A. Make sure the machine is connected
to a 240 VAC power supply.
B. Turn off the machine and allow the
engine to cool down before using
it again.
C. Have the machine inspected and
repaired by an authorized service
center.
The motor stops
during use.
A. Thermal overload
triggered.
A. Turn off the machine and allow the
engine to cool down before using it
again. Check that the saw blade is
correctly installed and adjusted and
that it is sharp.
Overheating of the
saw blade or burning
of the workpiece.
A. The saw blade is blunt.
B. Incorrect saw blade type.
C. Unsuitable workpiece
material.
A. Replace the saw blade.
B. Use the correct type of saw blade for
the material.
C. Don’t try to cut.
NOTE:
If you are unable to resolve the problem, please contact the Official Technical Service.
Summary of Contents for SRC350C
Page 2: ......
Page 78: ......
Page 79: ......
Page 80: ...www greencut es Manual revisado en noviembre de 2018...