55
EN
TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies.
PROBLEM
CAUSE
SOLUTION
The welder will not turn on.
Check fuses and power sources.
Replace fuses if necessary. If the problem
persists, contact your dealer.
The feed motor does not work.
The feed motor works but the
contact tip does not work.
Insufficient pressure on the reel.
Contact your dealer.
The cable is welded to the contact
tip.
The power cord becomes entangled.
Increase the pressure on the reel.
The coil is released, hitting the inside
walls of the welder.
Cut out the wire.
Power supply to the cable.
Clean with compressed air or replace.
Poor quality welding.
Use a new rod.
Very slow feeding.
Replace the reel.
The welder switches off while in
use.
Incorrect tip size.
Unscrew the tip, cut the wire and insert a new
tip by increasing the speed of the wire, before
re-operation.
The cable has been soldered to the tip.
Place a tip of the correct size.
El cable de alimentación se enreda.
Damaged protection that prevents
Reduce reel pressure.
cable slippage.
Renew the protection.
La bobina se suelta, golpeando las
paredes internas de la soldadora.
Loose lock nut.
Tighten the lock nut securely, but do not
overtighten.
Alimentación eléctrica del cable.
Lock nut too tight.
Slightly loosen the lock nut.
Worn reel.
Check and replace if necessary.
Soldeo de mala calidad.
Insufficient pressure on the reel.
Increase the pressure on the reel without
over-tightening.
Dirty, rusty or twisted wire.
Cut out the wire and make sure it is clean.
Protection locked.
Clean with compressed air.
Insufficient gas
Check that nothing is dissipating the gas. Go
to a protected area. Increase gas supply.
Rust, dirt, grease or oil in the
workpiece.
Make sure the workpiece is clean and dry.
Rusty or dirty wire.
Make sure the wire is clean and dry.
Poor grounding contact.
Check the connection between the earth
clamp and the workpiece.
La soldadora se apaga mientras
está en uso.
Excessive working limit (automatic
shutdown is activated).
Allow the welder to cool down for 15 to 30
minutes before continuing.
Welder too small for the operation being
performed.
Note: If the working limit has been exceeded,
the welder may be damaged.
NOTE:
If you are unable to resolve the problem, please contact the Official Technical Service.
