![background image](http://html1.mh-extra.com/html/greencut/jet140c-4/jet140c-4_instruction-manual_2261541047.webp)
47
EN
SPRAY LANCE
The adjustable spray lance allows you to use any variety of spray patterns by
turning the nozzle, from a fan spray to a tip-jet spray. When using the pressure
washer to clean wood decks, siding, vehicles, etc., we recommend that you
always start using the fan spray and begin spraying from a minimum distance of
36cm and an angle of 20° to avoid damaging the surface of the material you are
cleaning (Fig. Q).
ATTENTION:
Do not adjust the nozzle while the trigger is being
pulled.
BOTTLE OF SOAP
To penetrate and remove dirt more effectively, it is recommended to use the detergent dispensing function.
1. Connect the soap bottle to the spray lance until it locks in the correct position.
ATTENTION:
It is necessary to dilute the detergent for more effective cleaning. It is recommended
to dilute the detergent in a suitable container to the required concentration before use.
DISCONNECTION OF EQUIPMENT
1. Turn off the water supply to the tap.
2. Press the trigger to reduce the pressure in the appliance.
3. Pull out the water inlet hose and let the appliance run for a few seconds to allow the water to be stored
in the pump.
4. Turn off the appliance and disconnect the electrical plug from the socket.
5. Disconnect the pressure hose. To drain the waste water, lift the jet gun and press the trigger.
MAINTENANCE
Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION:
Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
For safety, clean the appliance every three months. Before putting the appliance into operation, check the filter and
nozzle for impurities. After the cleaning operation is complete, make sure that there is no water left in the pump and
hose.
Q
Summary of Contents for JET140C-4
Page 2: ......
Page 63: ......
Page 64: ...www greencut tools com Manual revisado en junio de 2021...