Diagram 3.
Skip to STEP 5. unless you wish
to change the factory set tune
and volume or house codes.
WIREFREE DOORCHIMES
Diagram 2.
Receiver
Diagram 1.
Transmitter
Before drilling any holes position
the transmitter on the door or door
frame outside (ideally a flat wooden
area) and press the button to ensure
the signals are getting through to
the receiver. Please test with the
door closed to simulate actual
working conditions. You should also
look to position the transmitter in
an unexposed place to protect from
rain.
The range of the unit is up to 100
metres but mounting the
transmitter on metal or UPVC
doorframes may make the unit
inoperative or seriously reduce the
operating range.
As with all low powered
transmitters the number of walls
and ceilings the signal has to travel
through, between the transmitter
and receiver also affects the range.
Once a suitable surface is found
remove the transmitter base
following 1a).Use this as a template
to fix the base on to a doorframe.
Ensure the transmitter is the right
way up so that
the slot is at the bottom.
If mounting on to masonry, wall
fixings will be required. Refit unit to
the base.
IMPORTANT : The screws must be
fixed flush or the battery will not
maintain contact with the terminals
and the unit will not operate.
The unit comes with a factory pre-
set tune but it can be changed.
The tune is determined by the slider
switch as in diagram 3.
Remove transmitter cover as in 1a)
above
leaving the battery in
and
select tune as shown in Diagram 3.
Press the push button to hear sound
each different setting produces.
Once a desired tune is selected,
carefully replace the transmitter. Up
to 3 different sound options are
available.
The unit comes with factory set
code. Only change it if you
experience interference from a
neighbours unit.
Remove cover transmitter from base
as in 1a) leaving the batteries in
position. Set dial as in Diagram 3. to
required number i.e “6”, set this
number “6” on the corresponding
dial on the reciever.
STEP 1. TESTING THE
TRANSMITTER WITH
BATTERY AND THE
PLUG-IN RECEIVER
STEP 3. TUNE SELECTION
MODEL NUMBERS:
DW030A: Plug-in Chime kit
• Simply plugs into a suitable mains
socket
• Battery included for Transmitter
(12V A23 Alkaline)
• Transmitter fixing screws included
Please read the instructions fully
before attempting installation.
1a) TRANSMITTER
The battery compartment slot is
located on the bottom of the unit.
Using a flat screw driver insert into
slot and gently push to remove the
lower cover.
Insert the two AAA batteries
supplied and refit the base cover.
1 b) PLUG-IN RECEIVER
Plug in to a mains three-pin socket
and switch the power on.
Press the button on the transmitter
and the doorchime will sound.
If there is no sound, ensure the
battery is correctly inserted in the
transmitter. Also ensure power is
switched on at the socket.
You have now tested your
doorchime.
STEP 2. INSTALLING THE
TRANSMITTER TO THE DOOR
STEP 4. CHANGING
THE HOUSE CODE
