Green Transporter Q Pod, Owner'S Manual, Page: 17 / 19

8. Battery charging method
(1) The following preparations should be performed before charging:
a.Check the charging equipment, instruments and tools, shall timely prepare or
repair them if there is a lack of or failure.
b.Must turn off the key.
c.Must use specified charger to charge and avoid damage the battery.
d.Open the charging protective cover.
e.Please check the tightening of every connection parts.
f.Must charge at airy, dry, no direct sunlight place.
g.Start the main power switch.
h.Must ensure that the socket is inserted in place, and the locking screw socket.
(2) Charging method
a.Power supply socket must match the charger plug.
b.Charging voltage is 110~220V.
c.Disconnect the ignition switch, remove the key, pull the handbrake, the main
power switch is at
“ON” place.
d.The charging plug is inserted into the charging port and tighten,
corresponding instrument indicator lights:
The red light on: charging;
Red light flashing: charging abnormal, please check the charging circuit is
connected or charger fault.
The green light on: full power, namely completion charging.
Note: A charging time is about 5-6 hours, after full charge, the charger will
automatically cut off power supply.
Note: Due to the charger power is about 2000W, in order to ensure the safety
of charging, must use special air conditioning socket, cable shall be not less than
1.5 square copper wire.
9. Traction motor maintenance
Always clean up the case of sediment and other attachments, to facilitate
cooling.
10. Rear axle maintenance
(1) Always remove the dirt, dust on rear axle ventilation plug.
(2) Always check the oil hole bolt and oil drain bolt, should timely tighten them or
replace sealing gasket once have any leakage phenomenon.
(3) Cleaning ventilation plug each 1200 miles: check the gear oil level in
bridge shell(open oil level plug to check).
(4) Check left and right bridge pipe fastening situation each 1200 miles, check
left and right
“U” shaped bolt of bridge pipe fastening situation.
(5) The first oil change mileage is 500 miles, must change the gear oil every 1000
miles later. Please make sure the service center is authorized by Manufacturer
before