Section 6 Clean and maintenance
1. Inspection
(1) Brake liquid
Timely check the brake fluid level between the highest mark(MAX) and the lowest
mark( MIN). If you need to replenish liquid, only can use DOT4 synthetic brake
fluid.
Note: The brake fluid will absorb moisture. Therefore, if the vehicle is used in the
humidity higher area most of the time, brake fluid replacement frequency should
be faster than usual, please go to service center to inspect and replenish brake
fluid.
Brake fluid is harmful to the human body and is corrosive, if accidental contact,
please wash related body parts with cleaning water and neutral soap immediately,
and repeatedly wash. If put in mouth by accident, seek medical advice
immediately!
(2) Battery
Running 15~20 days shall timely check the battery electrolyte, and timely
replenishment.( Note: each battery electrolyte hole should be replenished one by
one) Maintenance free batteries do not need to check the electrolyte.
2. Lamp maintenance
A. Introduction
Operating light switch to check all the lamps are working. If the lamp is not lit,
usually due to fuse or bulb failure. First check the fuse, if fuse is not burned, then
check the bulb. If fuse and bulb is ok, please drive your vehicle to service center to
repair.
B. General rules
(1) Ensure lamp is turned off before replacing bulb, and inspect whether
corresponding contact point is oxidized or not.
(2) Please replace the broken bulb by same model and power new bulb.
(3) Please inspect the headlight after replacing their bulb.
(4) The internal surface of headlamps will cast a thin layer of water vapor in the
morning, it
’s not a problem, is a normal phenomenon in low temperature and moist
air condition. That will quickly disappear after lighting lamp. The water appears
inside headlight, namely the water infiltrate inside, please drive your vehicle to
service center to repair.
(5) Do not use dirty gloves to hold the bulb. The oil on your hand will affect the
bulb replacement next time. If the glass surface dirty, must use alcohol, paint
thinner to clean. Completely dry and then re-install.
3.
Cleaning
Often use vacuum cleaner or soft brush to clean the dust on decorative pieces,
plastic pieces and seat inside the car. To scrub the vinyl plastic and leather surface
with a clean soft cloth stained with weak alkaline soap water, then with a dry soft
cloth. Before using any fiber protector, you should read the manufacturer
’s
Summary of Contents for Q Pod
Page 1: ...Q Pod Owners Manual...