Setup
The Beacon has a single-button, bicolour LED interface with quick access to the basic
functions. Further options can be set with the Green-GO update connection software.
To access the button functions, see the descriptions below.
Button functions
Cloning config
Press and hold the button for 10 seconds
à
The LED next to the button will rapidly flash green during the ten seconds. It will
then take the first config it finds on the network. It is advised to do this with only
one other config present on the network.
Setting Group mode and assigning a group
Press the button for 1 to 2 seconds
à
The LED next to the button will rapidly flash red to indicate pairing mode.
Send a call from another device to a group
à
The beacon will now be paired to this group and will report calls on that group.
Optional cue and talk reports can be set with the update connection software.
Setting user mode and assigning an user
Press the button for 1 to 2 seconds
à
The LED next to the button will rapidly flash red to indicate pairing mode.
Send a call from another device to a user
à
The beacon will now be paired to this user and will report calls on all channels of
that user. Optional cue and talk reports can be set with update connection.
Full reset to factory defaults
Press the button during powerup and release when powered up
à
This will start up the device in boot mode. The LED next to the button will rapidly
flash red to indicate that the device is in boot mode.
Press and hold the button for 30 seconds
à
During the countdown, the LED will alternate flashing red with green. The LED will
turn solidly green after 30 seconds, indicating that the device is now reset to
factory defaults. The LED will go back to flashing red when the device is ready.
Turn the device OFF and back ON
à
To return the device to normal operation.
Summary of Contents for GGO-BEACON
Page 1: ...Beacon Quick Start Guide...
