__________________________________________________________________________________
Green-GO Dante Interface X – Quick Start Guide
Program Audio
à
Set up the Program Audio channel for this Dante connection.
Mode
à
Select Normal or Local IFB. Normal mode will allow you to select.
one of the available Groups in the Green-GO network on the Program
audio channel. Local IFB will send the input of the Dante connection to
the Program audio of this port. This audio stream is not Available on
the Green-GO network.
Src
à
Select the Group as program audio source. Not available in Local IFB
Vol
à
Set the volume of the program audio. Range is Mute, -36 dB
through 12 dB
Dim
à
This will Attenuate the program audio whenever one of the
Channels including announcement and emergency is active. Range is
from 0 dB to -24 dB and MUTE option.
Audio In/Out
Output
à
Set the output level of the Dante Output. Range is MUTE, -42 to 6
dB.
LoopBack
à
Set the ratio of audio feed back from the input back to the output.
range is 0 to -39 dB or turned off.
AutoGain
à
Set the dynamic amplification to avoid distortion. Available settings
are Slow/Med/Fast/Off. If AutoGain is turned off the Max Gain
becomes gain.
MaxGain
à
Set the maximum gain of the input signal - range is from -12 to 28
dB.
Threshold
à
Set the gate function for this input. the threshold is the level
required for the input signal to be transmitted – editable range is
from -45 to -20dB or turned Off.
Hold
à
Set up the Gate hold time for this input. Options:
Fast/Med/Long/XLong
In
à
Set up the input source for this input. Line In or a 125 Hz to 4 kHz
test tone