1.
Make sure the lamp adapter is a L type and compatible with the L track system. (fig. 1)
Note: the L type adapter is compatoble with single or two-circuit track types. Simply lift the contact to its up position for two-circuit application.
2. Insert the head of adapter into the slot of the track rail making sure the locking tab is parallel to the track’s polarity line. (fig. 2)
3.
While holding the adapter up to the track, push the fixture upward, then twist the body of the fixture 90 degrees until the locking tab on the adapter snaps into the track groove.
(fig. 3)
Note: the ground pin needs to be touching the grounding pin. (fig. 4)
The adapter only rotates in one direction, therefore do not forcefully rotate the adapter in the wrong direction as it may damage it.
Removing the lamp
1.
While holding the fixture in place, gently twist the fixture 90 degrees until it can easily be removed from the track groove.
5
4
3
2
6
1.
Locate the accessory locking channel in the fixture holder ring (fig. 1). Locate the retainer clips on the edge of the accessory (fig. 2). Simply insert the edge of the accessory
into the locking channel of the holder until it clicks and is securely fasten.
2. To install the honeycomb with the snoot or wall wash accessory, gently push the mesh ring out from the honeycomb plastic ring. (fig. 4)
3. Insert the mesh ring, from the bottom of the snoot or the wall wash (fig. 5) until it’s firmly in place in the holder connecting part of the accessory. (fig. 6)
4. Then proceed to normal accessory installation as described above.
ACCESSORY INSTALLATION
For use with ATOM track series.
www.greencreative.com - [email protected] - Tel / Fax: (866) 774-5433 - / GREENCREATIVELED / GClightingLED / GREEN-CREATIVE
An ILLUMUS Brand
