VIREO GEN3
OWNERS MANUAL - INDOOR UNIT
|
11
OPERATION OF WIRELESS REMOTE CONTROLLER (Continued)
Remote controller operations
The wireless remote controller is sleek, versatile and
allows you to change room temperatures and functions
on your Sapphire system from the palm of your hand.
The large LCD display and buttons make it easy-to-
understand and easy-to-use.
The remote controller is set from factory to display
temperatures in °F. If °C is desired, turn the remote
controller OFF with the ON/OFF button and then press
“MODE“ and “-” buttons on the remote simultaneously
for 5 seconds.
ON/OFF
When the system is in OFF mode, the remote controller
will display the time and last room setpoint. When you
press the ON/OFF button, the unit will start in the last
operating mode and room setpoint.
NOTE:
• If the ON/OFF button is pressed too soon after a
stop, the compressor will not start for 3 to 5 min.
due to the inherent protection against frequent
compressor cycling.
X-FAN MODE
When operating in humid areas, the unit has a DRY
COIL function called X-Fan that will allow the indoor
fan to run for a pre-determined amount of time after
the unit is turned off (cooling or dry modes) to ensure
that additional moisture is removed from coil. Hold
“FAN” button for 2s in COOL or DRY mode to enable this
feature. The X-FAN
icon will be displayed on remote
controller. To deactivate this feature, hold “FAN” button
for 2s again.
LOCK MODE
The Privacy Lock prevents unauthorized access to
the unit controls and prevents tampering with system
settings. The remote controller can be locked by
pressing the”+”and “–”. The Privacy Lock icon will be
displayed on the remote controller.
Repeat the process to unlock the remote controller.
MODE
Use the “MODE” button to select one of the available
modes. The selected mode will be displayed on
the remote controller and the appropriate light will
illuminate on the front display Zpanel.
• AUTO – Unit will automatically select heating or
cooling to maintain room temperature between 68°F
and 77°F. The remote controller will display the Auto
Mode icon with no setpoint. The front panel display
will show “68 or 77.”
• COOL – Cool to selected setpoint and remove moisture.
System varies compressor speed to maintain desired
temperature.
• HEAT – Heat to selected room setpoint. System
varies compressor speed to maintain desired room
temperature.
• FAN ONLY – To circulate air without heating or
cooling. Use Fan Speed button to select speed from
low to high.
• DRY – Select DRY MODE to increase moisture removal
during warm humid conditions.
