OFF
1
0
2
3
4
8
7
6
5
13
14
OPERATION OF WIRELESS REMOTE CONTROLLER
X-Fan Mode Display
Swing Louver Display
VERTICAL SWING LOUVERS
• Press the Vertical Swing Louver button to select five
different vertical (up & down) air discharge directions
including Continuous Sweep. The Vertical Swing Louver
icon will be displayed. Press this button to set
swing angle, which circularly changes as below:
Indicates louver swings back and forth in the five
places, as shown in the figure.
X-FAN MODE
When operating in humid areas, rio has a
DRY COIL
function
called X-Fan that will allow the indoor fan to run for a pre-determined
amount of time after the unit is turned off (cooling or dry modes)
to ensure that additional moisture is removed from coil. Push the
“
X-FAN
” button to enable this feature. The
X-FAN
icon will
be displayed on remote controller. To deactivate this feature, push
the “
X-FAN
” button again.
TIMER MODE
The Rio can be programmed to automatically turn
ON
or
OFF
after
a selected time period. Press
TIMER
button to activate the
TIMER
mode. In
TIMER
mode the
HOUR ON/OFF
icon will begin blinking.
Press + or - button to select a time setting from 0.5 to 24 hours. Press
once for slow adjustment and hold down for fast adjustment. Press
TIMER
button to confirm settings and
HOUR ON/OFF
icon will stop
blinking. The unit will turn
ON
or
OFF
after the selected time period.
OPERATION OF WIRELESS REMOTE CONTROLLER
TURBO MODE
The desired setpoint, either in heating or cooling, can be achieved
faster if
TURBO
mode is used. After selecting the “
HEAT
” or
“
COOL
” mode button, push the “
TURBO
” button. The
TURBO
icon will be displayed on the remote controller and the unit
will run at ultra high speed fan. To deactivate the feature, push the
“
TURBO
” button again. The unit will return to normal operation.
SLEEP MODE
The rio will automatically adjust room temperature during
your sleep time. This slight change in temperature will not affect
your comfort level due to the natural effects that sleeping has on
the body, but it will save on energy consumption and will lower
your electric bill. Press the SLEEP button to select Sleep Mode.
The SLEEP icon will appear.
In Cool or Dry modes:
The unit will run at current room setpoint for 1 hour.
After 1 hour, the setpoint will increase by 2° F.
After 2 hours, the setpoint will increase by 4° F and
maintain this setpoint until Sleep Mode is cancelled.
In Heat mode:
The unit will run at current room setpoint for 1 hour.
After 1 hour, the setpoint will decrease by 2° F.
After 2 hours, the setpoint will decrease by 4° F and
maintain this setpoint until Sleep Mode is cancelled.
Turbo Mode Display
Sleep Mode Display
