7
OPERATION METHODS
Timer set
1.Set timer-off
Press the Timer button when the unit is on. The LED will flash_ _five
Times. During this period press Up or Down button to adjust set time from
0.5h to 24h. It will vary 0.5h each time in 3h and 1h each time hereafter. The
set time will flash 5 times after adjusting. When it will display temperature
again. Once the set time end, the unit will turn off automatically.
2. Change the set time
When Timer is on, you can check remnant time by pressing Timer button. It
will flash 5 times. Press Up or Down button to adjust set time. The set time
can also be cancelled if you press the Timer button once again during the
flashing time
.
3.Set timer-on
Press the Timer button when the unit is off. Same as timer-off set. Once the
set time end, the unit will turn on automatically.
Cooling/Heating and Dehumidifying operation
1.Cooling/Heating operation
Press Mode button or
/
to choose Cool/heat mode.
Press Up or Down button or
to set a proper room temperature.
The range is 18~30
℃
(64-84
°
F). The temperature will increase or decrease
1
℃
or 1
°
F each time.
Press Speed button or
to choose a proper fan speed.
Press Swing button or
to adjust the direction of vertical louver.
Adjust horizontal louver by hand.
2.Dehumidifying operation
Press Mode button or
to choose Dry mode. The fan speed is Low,
LED displays room temperature. These cannot be adjusted.
NOTE:
1. In cool mode, when the water Injection indicates lights, you can inject
some water through the injection port before cooling operation (no
longer than High level).
2. You should drain water with the drainpipe in heat and dehumidifying
mode. The unit will stop work when water level exceeds the high level.
3. Do not use air exhaust duct when in Dry or Fan modes
4. If your room is directly exposed to the sun, draw the curtains please.
