71
Installation and Maintenance
Service Manual
Step
Procedure
8.Remove Front Case
Remove 2 screws used for fixing the front case
and 1 screw used for fixing the WIFI, turn over the
front case, pull the front case upwards to loose the
upper clasp, and then remove the front case.
9. Remove Electirc Box
Remove screws used for fixing the electric box
cover, use the screwdriver to loose the clasp at the
rear of electric box cover, and then the electric box
cover can be removed.
Remove the screws used for fixing indoor and
outdoor connection wires on the wiring board, the
screws used for fixing the grounding wire on the
evaporator and then screws used for fixing the
cold plasma. Pull out the wiring terminal of tube
temperature sensor and main board, press the
clasp at the bottom and then pull the electric box to
the right side.
Screws
Clasp
Screw
Wiring terminal of left&right driving box
WIFI wiring terminal
Wiring terminal of
cold plasma
Wiring terminal of
display board
W i r i n g
terminal
of motor
Jumper cap
Fuse
