Service Manual
Installation and Maintenance
31
4.Carefully slide the chassis into the sleeve. Ensure that the ground
wire is not pinched or in the path of the condenser fan.
5.Loosen locking plate screw and rotate tab with tab behind wall
case flange (See Figure C) then tighten locking plate screw.
6.If outlet is on the left side of the unit. route power cord as shown
in Figure D.
To replace front grille:
Hook the tabs on the front grille even with the tabs on the case and
snap into place. Replace the screws and filter. Refer to Figure A.
VENT CONTROL AND AIR DIRECTION
(See Figure E)
The vent control is located behind the front grille on the right side of
the air discharge area. When set at CLOSE only the
air inside the room will be circulated and conditioned. When set at
OPEN, some inside air is exhausted outside.
To open or close the vent:
1. Remove the front grille.
2. Remove the vent card screw.
3. Remove the vent card, turn it over and replace it by locating rear
hole in card over locating pin inside air discharge and reattaching
screw at front.
AIR DIRECTION
Horizontal louvers on the front grille let you control the air
direction up and down.
Locking
Plate
Figure C
Figure E
Figure 4
Figure D
Power
Cord
Clamp
Tab
Grille
Locating
Locating
Hole
Hole
Screw Hole
Screw Hole
OPEN position
CLOSE position
(Mesh end toward back)
(Mesh end toward front)
EXHAUST AIR VENT
