Gree FP-102BA2/B-D, Service Manual

Page: 28 / 67

Wall Mounted Type
Fan Coil Unit Service Manual
26
4�10 E-Heater
“ E-heater ” Function: Under the “ Heat ” mode, the heating efficiency can be improved greatly by activating
the auxiliary electric heater.
How to active the “ E-heater ” function: Under the “ Heat ” mode, press the “ Function ” key to go to the setting
state with the symbol“ ” flashing, after that, press “ Enter/Cancel ” to make a confirmation and then the
symbol will stop flashing.
How to deactivate the “ E-heater ” function: When the “ E-heater ” function is activated, press the“ Function ”
key to go to the setting state of the “ E-heater ” function with the symbol“ ”flashing, after that, press the “
Enter/Cancel ” key to deactivate this function and then the symbol“ ”will disappear.
See Fig. 20 for how to activate the “ E-heater ” function.
Press “ Function ” to go
to the setting status
When the “ E-heate r”
function is not activated
Press “ Enter/cancel ” to
activate the “ E-Heater ”
function
Fig. 20 How to Activate the “
E-heater
” function
See Fig.21 for how to deactivate the “ E-heater ” function.
When the “ E-heater ”
function is activated
Press “ Function ” to go to
the setting status
Press “ Enter/cancel ” to
dectivate the “ E-Heater ”
function
Fig.21 How to Deactivate the “ E-heater ” Function
NOTE:
①
The “ E-heater ” function is unavailable under the “ Cool ”, “ Dry ” or “ Fan ” mode and the symbol “ ”
will not be displayed on the LCD under those modes.
②
When the unit is switched to the “ Heat ” mode, the default status of the “ E-heater ” function is “ On ”.
4.11 Blow
“ Blow ” Function:It is intended to dry the moisture inside the evaporator after the unit is turned on to prevent
mould growing there.
How to activate the “ Blow ” function:Under the “ Cool ” and “ Dry ” mode, when the “ Blow ” function is not
activated, press the “ Function ” key to go to the setting state with the symbol“ ”flashing, and then press the
key “ Enter/Cancel ” to make a confirmation.
How to deactivate the “
Blow
” function:When the unit is “
On
” and the “
Blow
” function is activated, press “
Function ” function to go to the setting state with the symbol “
”
flashing, and then press the “ Enter/Cancel ”
key to deactivate this function.