8
Technical Information
Service Manual
6. Function and Control
button
Swing
Press this button to turn “ON” & “OFF” swing.
button
Fan
This button is used for setting Fan Speed in the sequence that
goes from AUTO, ,
, to
, then back to Auto.
Auto
Speed 1
Speed 2
Speed 3
NOTE: There are 3 speeds for the Fan Speed of this model.
button
Sleep
Press this button to go into the Sleep operation mode. Press it
again to cancel this function. This function is available in COOL,
HEAT (Only for models with heating function) mode to maintain
the most comfortable temperature for you.
button
Timer
Under ON status, press this button to set timer OFF; Under OFF
status, press this button to set timer ON.
Press this button once and the characters of HOUR ON (OFF)
will flash to be displayed. Meanwhile, press “+” button or “-”
button to adjust timer setting (time will change quickly if holding “+”
or “-” button). Time setting range is 0.5~24hours.
Press this button again to confirm timer setting and the characters
of HOUR ON (OFF)will stop flashing.
If the characters are flashing but you haven’t press timer
button,timer setting status will be quit after 5s.If timer is confirmer,
press this button again to cancel timer.
button
Health
Press this button to turn on or turn off the health and scavenging
functions in operation status.Press this button for the first time to
start scavenging function LCD displays "
". Press the button
for the second time to start health and scavenging functions
simultaneously; LCD displays "
" and "
". Press this
button for the third time to quit health and scavenging functions
simultaneously.
Press the button for the fourth time to start health function; LCD
display "
".
Press this button again to repeat the operation above
button
WiFi
When WiFi function is turned on, " WiFi " icon will be displayed
on the remote controller; when WiFi function is turned off, " WiFi "
icon will disappear.
How to turn on WiFi: Press " WiFi " button to turn on WiFi
function.
How to turn off WiFi: Hold " WiFi " button for 5s to turn off WiFi
function.
Under off status, press "MODE" and " WiFi " buttons
simultaneously for 1s, WiFi module will restore factory settings.
●This function is only available for some models.
Function introduction for combination buttons
Temperature display switchover function
Under OFF status, press "-" and "Mode" buttons simultaneously
to switch temperature display between °C and °F.
Light function
Under switch-on or switch-off state, you may hold "+"and "FAN"
buttons simultaneously to set the lamp on or off and send the
code. After being energized the lamp is defaulted on.
Replacement of batteries in remote controller
battery
remove
reinstall
Cover of battery box
signal sender
1. Press the back side of remote controller marked with " ", as
shown in the fig, and then push out the cover of battery box along
the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the
position of "+" polar and "-" polar are correct.
3. Reinstall the cover of battery box.
Notice
：
● The distance between signal sender and receiving window
should be no more than 8m, and there should be no obstacles
between them.
● As the signal will be interfered in the room with electronic
fluorescent lamp,conversion fluorescent lamp or wireless
phone ,please get closer to the air conditioner when using the
remote controller.
● Replace new batteries of the same model when
replacement is required.
● When you don’t use remote controller for a long time,
please take out the
batteries.
