ELECTRICAL REQUIREMENTS
1.
The air conditioner must be grounded ; it is equipped with a LCDI
(Leakage Current Detection and Interruption) power cord and plug
This feature will circuit trip the electrical power source if the nominal
current leakage between the cord shield and either load conductor
exceeds a predetermined value. The cord will remain out of power
until the device is manually reset. This is intended to protect against
electric shock and to reduce the risk of a fire in the power cord or
combustible materials nearby. The cord shield is not grounded and
must be considered a shock hazard if exposed. The cord shield
must not be connected to ground or to any exposed metal.
2.
Do not cut or bypass the plug ground prong. If you do not have a grounded outlet available
near the air conditioner, have one installed by a qualified electrician.
3.
The power supply rated voltage is ± 6%.
4.
Do not connect the unit to an outlet being used by other appliances; ideally, connect to a single
grounded 15A circuit (time-delay fuse or circuit breaker).
5.
If the power cord or plug is damaged, call SUNRISE TRADEX Customer Service.
• Electrical ratings of the air conditioner are detailed on the rating plate on the back of the unit.
• Basic electrical requirements are listed hereafter. Please make sure to check the following before
installing and connecting your unit.
INSTALLATION
5
Casters
Drain hose
Cap
Clamp
Rear grille
PREPARING THE AIR CONDITIONER
F
IXING THE CASTERS
(Some models only)
To avoid the risk of causing damages to the air conditioner,
you must install the casters before using the appliance.
1.
Open the accessory bag and take the 4 casters out.
2.
Recline the unit, one side at a time, to insert the unit into
the base holes. Do not recline the unit more than 45°
from the ground.
3.
Screw the casters into the base threaded holes.
I
NSTALLATION OF THE DRAIN HOSE
(Some models only)
You must fix the drain hose before operating the unit.
1.
Take out the drain hose, the hose cap and the clamp
from the accessory bag.
2.
Insert the drain hose into the drain hole on the lower
back of the unit. Make sure that the drain hose is
correctly inserted into the drain hole.
3.
Put the hose cap on the free end of the drain hose.
4.
Fix the drain hose on the rear grille with the clamp.
