15
INSTALLING DEPTH ROD – cont’d
3. Position the depth rod so the tip of the
round end (5) will contact the
workpiece when the drill reaches the
appropriate depth.
NOTE:
Auxiliary handle must be
placed in the horizontal position to
allow depth rod to be inserted into the
mounting collar. Tighten the auxiliary
handle.
INSTALLING BITS
WARNING:
Never hold the chuck
body with one hand and use the drill
power to rotate the drill body to loosen
or tighten bits. You may severely injure
your hand.
1. Remove drill plug from the power
source.
2. Rotate chuck collar (1) to open or
close the jaws (2) to a point where the
opening is slightly larger than the bit
size you intend to use (Fig. 7). Raise
the front of your drill slightly to prevent
the bit from falling out of the chuck
jaws.
3. Insert the drill bit into the chuck the full
length of the jaws.
4. Insert chuck key (3) into one of three
holes in the chuck body. Rotate chuck
key clockwise until drill bit is held
firmly in place by the chuck jaws.
NOTE:
Do not use a wrench on the
chuck key or you may damage the key
or chuck.
!
ASSEMBLY AND OPERATION
Fig. 7
Summary of Contents for 80159
Page 21: ...PARTS DIAGRAM MODEL 80159 21...
