GREAT PLAINS YP1630F-1630, Operator'S Manual, Page: 26 / 142

Great Plains | 401-832M | 2018-07-31 Table of Contents Index 22
YP1630F-1630 and YP1630F-1670 Table of Contents Index Operating Instructions
Operating Instructions
This section covers general operating procedures.
Experience, machine familiarity and the following
information will lead to efficient operation and good
working habits. Always operate farm machinery with
safety in mind.
Pre-Start Checklist
1. Carefully read “ Important Safety Information ” on
page 1.
2. Lubricate planter as indicated under “ Lubrication ”
on page 98.
3. Check all tires for proper inflation. See “ Tire
Inflation Chart ” on page 112.
4. Check all bolts, pins and fasteners. Torque as shown
in “
Torque Values Chart ” on page 120.
5. Check planter for worn or damaged parts. Repair or
replace parts before going to the field.
6. Check hydraulic hoses, fittings and cylinders for
leaks. Repair or replace before going to the field.
7. Be sure hydraulic hoses are securely held out of the
ball swivel area at hitch. Failure to do so could cause
hoses to pinch requiring hose replacement.
Wing Lock Overview
Refer to Figure 9 and Figure 10
The YP1630F planters include four sets of locks for the
frame and wings:
1. Transport hooks behind the wing pivots:
These prevent the planter frame from fully lowering
when folded. The planter frame is raised to allow the
wings to clear the hooks. See page 23 and 28.
2. Wing locks at mid-tongue and inside wing casters:
These prevent the planter from unfolding while in
transport. The tongue (hitch) is raised to allow the
hooks to clear the locks. See page 24 and 28.
3. Transport lock channels at wing caster cylinders:
These lock channels prevent the frame from fully
lowering during transport and maintenance. They
are installed prior to folding, and removed after
unfolding. See page 25 and 29.
4. Lift cylinder lock channels above frame pivots:
These lock channels are only required during
maintenance. However, if installed, they must be
removed after unfolding. See page 25 and 72.
High Pressure Fluid Hazard:
Check all hydraulic lines and fittings before applying pressure.
Escaping fluid under pressure can have sufficient pressure to
penetrate the skin. Fluid escaping from a very small hole can
be almost invisible. Use paper or cardboard, not body parts,
and wear heavy gloves to check for suspected leaks. If an
accident occurs, seek immediate medical attention from a
physician familiar with this type of injury.
Figure 9
Lift Locks and Transport Hook
34571
1
4
2
2
Figure 10
Wing Lock and Transport Locks
34550
2
3
3
2