GREAT PLAINS Turbo Max 1200TM, Operator'S Manual, Page: 22 / 40

07/09/2018 Table of Contents Index 586-535M
1200-1500TM Table of Contents Index Preparation and Setup 18
Weight Package Assembly (Optional)
Refer to Figure 14
Caution:Lower machine until coulters are on ground and
pressure is off leveling system.
 Up to 1 set of weights (2 weights) may be used in
positions shown.
31. Start by removing the 3/4 x 2 Gr. 8 bolts from level
bar assembly.
32. Pivot level bar up so there will be clearance to set
the 750 pound weight assemblies into place.
33. Pivot level bar spring assembly forward.
34. Carefully lower the 750 pound weight assemblies
onto center frame trusses .
35. Slide rear weights as far forward as possible and
install weight box stops on inside of trusses as
close to weight as possible (rear weights), secure
with 1/2 x 4 1/32 x 5 1/4 u-bolt , 1/2 lock washers
and 1/2 nuts.
36. Torque u-bolts to 85 ft-lbs.
Refer to Figure 15
37. Pivot level bar and the level bar spring assembly
until holes in plates are aligned.
38. Re-install 3/4 x 2 Gr. 8 bolts , secure with 3/4 lock
washers and 3/4 nuts.
39. Torque 3/4 x 2 Gr. 8 bolts to 375 ft lbs to be sure
bolts do not work loose and cause damage to
machine.
2
5
7
6
5
4
1
3
Figure 14
Weight Package
43105
1
2
4
3
4
5
6
7
2
1
3
Figure 15
Level Bar
43106
1
3
1
1